PRO-505 TEKNAgrip® Pre-Pasted Wallcovering Activator

PRO-505 TEKNAgrip makes hanging pre-pasted wallpaper easier with better results. PRO-505 eliminates messy water trays and increases slip allowing for easier pattern matching. The added holding power also helps minimize split and open seams.

Recommended Use

  • Hanging pre-pasted wallpaper

Key Features

  • Added holding power
  • Longer open time and more slip to match patterns
  • Minimizes seam separation
  • Eliminates messy water tray
  • VOC (Actual): < 1%
  • VOC (Regulatory): < 5 g/L

This product is currently out of stock and unavailable.

1-Gallon
1-Gallon

ROMAN recommends contacting the retailer before purchase to ensure that the product you are looking for is available.

Application Instructions

Surface Preparation: Surface must be free from grease and other residues, dry, smooth and structurally sound. Check surfaces for paint bonding, loose wallcoverings, damaged wall-board or plaster. Repair all unsound surfaces. Before proceeding with any unusual conditions, consult your adhesive or wallcovering supplier.

Dilution: Do not dilute

Application Method: Use only when the room temperature is above 50°F. Apply an even coat of adhesive with a roller or brush. Avoid contact with the surface of embossed, textured or delicate wallcoverings. Book wallcovering according to the wallcovering manufacturer’s instructions.

Clean-Up: Before the adhesive dries, remove any excess with clean water. Additional effort may be required if the adhesive is allowed to contact the surface of embossed or textured vinyls.

Warning

If you scrape, sand, or remove old paint, you may release lead dust. LEAD IS TOXIC. EXPOSURE TO LEAD DUST CAN CAUSE SERIOUS ILLNESS, SUCH AS BRAIN DAMAGE, ESPECIALLY IN CHILDREN. PREGNANT WOMEN SHOULD ALSO AVOID EXPOSURE. Wear a NIOSH-approved respirator to control lead exposure. Clean up carefully with a HEPA vacuum and a wet mop. Before you start, find out how to protect yourself and your family by contacting the National Lead Information Hotline at 1-800-424-LEAD or log on to www.epa.gov/lead.

Roman Products, LLC does not endorse the use of any product in an installation that does not meet a Class A fire rating or any applicable code. Testing by a certified laboratory should be conducted to verify that the installation meets a Class A fire rating and to guarantee compliance with all applicable codes. Specifically, if a Roman product is used to hang wallpaper over existing wallpaper, it is unlikely to meet these standards.

Limited Warranty

Roman Products, LLC warrants that it will replace this product free of charge, if, within 12 months of manufacture, it is found to be defective in material or workmanship. This warranty is in lieu of any other. The exclusive remedy is limited to the replacement of the product and Roman disclaims all liability for consequential, punitive, and special damages. Conditions of use are beyond our control.

Caution

Store in a cool, dry place. DO NOT FREEZE! Do not take internally. In case of ingestion, seek medical attention. Avoid contact with skin and eyes. Use of skin and eye protection is recommended at all times. If contact with eye occurs, flush with water for 15 minutes. If skin contact occurs, wash with soap and water. Seek medical attention if rash or other symptoms occur. Do not mix with other chemicals. Use in a well-ventilated work area. Close container after each use. Keep out of reach of children.

Reviews

There are no reviews yet.

Be the first to review “PRO-505 TEKNAgrip® Pre-Pasted Wallcovering Activator”

Specifications

                       
Product Type Specialty Wallcovering Adhesive - Pre-pasted Activator
Coverage Approximately 360 square feet per gallon
VOC (Regulatory) < 5 grams/Liter
VOC (Actual) < 1%
Viscosity Approximately 17,000 cps
pH Level 11.0
Color Clear
Interior/Exterior Interior
Drying Time Drying time will vary depending on the temperature, ventilation and humidity of the room.
Product Storage Do not freeze. Keep in a cool, dry place.
Percent Solids Approximately 59%
Dilution Rate Do not dilute

Safety Data Sheets

Technical Data Sheets

USDA CERTIFIED BIOBASED

ROMAN products featuring a “USDA® Certified BioBased Product” logo have achieved third-party verification of biobased content and have earned USDA Certification.

BioBased products are commercial or industrial products composed, in whole or in significant part, of biological products such as renewable domestic agricultural materials like corn and wheat. These BioBased products provide an alternative to conventional petroleum derived products.

For more information on the USDA BioPreferred program, please visit: https://www.biopreferred.gov/BioPreferred/faces/pages/AboutBioPreferred.xhtml