E-Z Hang Peel & Stick Helper + Pre-Pasted Activator

Application Instructions

Surface Preparation: Surface must be free from grease and other residues, dry, smooth, and structurally sound. Repair all unsound surfaces. Consult your wallpaper supplier before installing under unusual conditions. Use only when the room temperature is above 60° F. Avoid contact with the surface of embossed, textured, or delicate wallpaper. Shake well before use.

For Peel & Stick Wallpaper: Working one section at a time, spray a generous amount of E-Z Hang on the wall surface. Apply the wallpaper according to the manufacturer’s instructions.

For Pre-pasted Wallpaper: Hold spray nozzle 10-12 inches from the wallpaper and apply a generous amount of E-Z Hang to the back of the wallpaper. Ensure edges and corners are well covered. Book and hang wallpaper according to the manufacturer’s instructions.

Clean-Up: Before the E-Z Hang dries, remove any excess with clean water. Additional effort may be required if the adhesive is allowed to contact the surface of embossed or textured vinyls.

Limited Warranty

ROMAN Products, LLC warrants that it will replace this product free of charge, if, within 12 months of manufacture, it is found to be defective in material or workmanship. This warranty is in lieu of any other. The exclusive remedy is limited to the replacement of the product and Roman disclaims all liability for consequential, punitive, and special damages. Conditions of use are beyond our control.

Caution

Store in a cool, dry place. DO NOT FREEZE! Do not take internally. In case of ingestion, seek medical attention. Avoid contact with skin and eyes. Use of skin and eye protection is recommended at all times. If contact with eye occurs, flush with water for 15 minutes. If skin contact occurs, wash with soap and water. Seek medical attention if rash or other symptoms occur. Do not mix with other chemicals. Use in a well-ventilated work area. Close container after each use. Keep out of reach of children.